HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Preparation for check


      1. Confirm the standard, high and low positions of the link that will be used in the following inspection.


        • The standard position is 58° from the maximum link angle (high) and 51° from the maximum link angle (low).

        • The high position (+45°) is 13° from the maximum link angle (high).

        • The low position (-45°) is 6° from the maximum link angle (low).

        A003MMWC02
        *a Standard Position *b Maximum Link Angle (Low)
        *c Maximum Link Angle (High) *d 51°
        *e 58° *f -45°
        *g +45° *h 6°
        *i 13° - -

      2. Connect 3 dry cell batteries (1.5 V) in series.

        Note

        Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

      3. Connect a positive (+) lead from the batteries to terminal 3 and a negative (-) lead to terminal 1.

        A003MJWC04
        *a

        Component without harness connected

        (Rear Height Control Sensor Sub-assembly LH)

        		 *b Low
        *c Standard Position *d High
        *e -45° *f +45°

      4. Measure the voltage between terminals 2 and 1 while slowly moving the link up and down.

        Standard Voltage
        Tester Connection Condition Specified Condition
        2 - 1 +45° (High) 4.5 V
        2 - 1 0° (Standard position) 2.5 V
        2 - 1 -45° (Low) 0.5 V

        If the result is not as specified, replace the rear height control sensor sub-assembly LH.