STOP LIGHT SWITCH INSTALLATION

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A003LJ4

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A003NZQE01

      Turn the stop light switch assembly 1/4 clockwise to install it.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
      or less

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the plunger.

      Protrusion of the Plunger
      Area Measurement
      a 0.6 to 2.6 mm (0.0236 to 0.102 in.)

    5. If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

      for LHD
      Click here Click here
      for RHD
      Click here Click here

      Note

      Do not depress or support the brake pedal.

  2. INSTALL NO. 2 AIR DUCT (for RHD)

    Click here

  3. INSTALL PARKING BRAKE MOUNTING BRACKET (for RHD)

    Click here

  4. INSTALL FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  5. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for RHD)

    Click here

  6. INSTALL REAR CONSOLE BOX ASSEMBLY (for RHD)

    Click here

  7. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here