HEADLIGHT DIMMER SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight dimmer switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Intelligent clearance sonar system*1
		Simple intelligent parking assist system*1
		Pre-crash safety system
		Adaptive High Beam System
		Parking assist monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
Removal/installation of the spiral cable with sensor sub-assembly	Steering angle neutral point (Initialize intelligent clearance sonar system)	Intelligent clearance sonar system Simple intelligent parking assist system Parking assist monitor system	Click here
	Steering angle setting	Parking assist monitor system	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Click here
REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Click here
REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
1. Disconnect the connector.
2. Disengage the 3 claws and remove the headlight dimmer switch assembly.