REAR TURN SIGNAL LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear turn signal light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly

  • Ultrasonic sensor detection angle (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle registration (w/ Intelligent clearance sonar system)

  • Intelligent clearance sonar system

  • Simple intelligent parking assist system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE REAR TURN SIGNAL LIGHT ASSEMBLY


    1. w/o Rear Fog Light:


      1. A003N5P

        Disconnect the 2 connectors.

      2. Disengage the 3 clamps.

    2. w/ Rear Fog Light:


      1. A003KAA

        Disconnect the 3 connectors.

      2. Disengage the 3 clamps.

    3. A003OZDC01
      B006IR6 Screw (A)
      B006IKP Screw (B)

      Remove the 2 screws (A).

    4. Loosen the screw (B).

    5. A003NH6C01
      B006IOI Protective Tape

      Apply protective tape around the rear turn signal light assembly as shown in the illustration.

    6. Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration.

      A003L82C01
      *a Protective Tape - -
      B006J86 Insert Screwdriver Here - -
    7. A003KMP

      Remove the screw and rear turn signal light assembly.