HEADLIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle registration (w/ Intelligent clearance sonar system)

  • Intelligent clearance sonar system

  • Simple intelligent parking assist system

Click here

Change grille shutter control mode and/or perform initialization Grille Shutter system

Click here

No. 1 headlight ECU sub-assembly LH

  • Synchronize vehicle information

  • Initialize No. 1 headlight ECU sub-assembly LH

  • Automatic headlight beam level control system

  • Adaptive high beam system*1

Click here

*1: w/ Adaptive High Beam System

Note

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE FENDER APRON MUDGUARD SEAL SUB-ASSEMBLY


    1. A003OKG

      Remove the clip.

    2. A003M9RC01
      B006IFV Remove in this Direction

      Disengage the clip to remove the fender apron mudguard seal sub-assembly as shown in the illustration.

  3. REMOVE HEADLIGHT ASSEMBLY


    1. A003LW3C01
      B006IOI Protective Tape

      Apply protective tape around the headlight assembly as shown in the illustration.

    2. A003O4PC01
      *a Connector Lock Lever
      B006IFV Disconnect in this Direction

      Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector.

    3. A003N7WC01
      *a Bolt
      *b Screw

      Remove the bolt and 3 screws.

    4. A003KYIC01
      B006IFV Remove in this Direction

      Disengage the guide to remove the headlight assembly as shown in the illustration.