FRONT TURN SIGNAL LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front turn signal light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle registration (w/ Intelligent clearance sonar system)

  • Intelligent clearance sonar system

  • Simple intelligent parking assist system

Click here

Change grille shutter control mode and/or perform initialization Grille Shutter system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY


    1. w/ TOYOTA Parking Assist-sensor System:


      1. A003JXXC01
        B006IR6 Screw (A)
        B006IKP Screw (B)

        Disengage the clamp.

    2. Remove the 2 screws (A).

    3. Loosen the screw (B).

    4. A003LL9C01
      B006IOI Protective Tape

      Apply protective tape around the front turn signal light assembly as shown in the illustration.

    5. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claw as shown in the illustration.

      A003MT9C01
      *a Protective Tape - -
      B006J86 Insert Screwdriver Here - -

    6. Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration.

      A003KDGC01
      *a Protective Tape - -
      B006J86 Insert Screwdriver Here - -

    7. Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration.

      A003NZCC01
      *a Protective Tape - -
      B006J86 Insert Screwdriver Here - -
    8. A003MUL

      Remove the screw.

    9. Disengage the guide to remove the front turn signal light assembly.