CHARGE LID OPENER SYSTEM DATA LIST / ACTIVE TEST


  1. Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    DATA LIST


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Plug-in Control / Data List.

    5. Read the Data List according to the display on the GTS.


      Powertrain > Plug-in Control
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Charging Lid Switch Status Charging lid switch status OFF/ON

      OFF: Charging port lid close (push lifter of EV charger lid switch assembly (charging lid courtesy switch) pushed in)

      ON: Charging port lid open (push lifter of EV charger lid switch assembly (charging lid courtesy switch) extended)

      		 -
      Charging Lid Lock Pin Request Status Charging port lid lock unlock request signal Unlock/Lock

      Unlock: Charging port lid unlocked (charging port lid lock pin not extended)

      Lock: Charging port lid locked (charging port lid lock pin extended)

      		 -
      Charging Connector Connect Status Voltage PISW terminal voltage used for checking electric vehicle charger cable assembly connection condition 0.00 to 79.99 V

      0.35 to 2.02 V: Electric vehicle charger cable assembly inserted (Power not supplied)*1

      1.25 to 2.02 V: Electric vehicle charger cable assembly inserted (Power supplied)*1

      2.02 to 3.57 V: Electric vehicle charger cable assembly inserted and the latch release button (PI switch) engaged*1

      3.57 to 4.75 V: Electric vehicle charger cable assembly not inserted*1

      0.35 to 4.50 V: Electric vehicle charger cable assembly inserted*2

      4.50 to 5.00 V: Electric vehicle charger cable assembly not inserted*2

      		 -
      Charging Connector Lock Pin Status Charging connector lock pin status Unlock/Lock

      Unlock: Charging connector lock pin not extended

      Lock: Charging connector lock pin extended

      		 -
      Charging Connector Lock Motor Unlock Direction Revolution Request Current Output of current to operate charging connector lock motor or charging port lid lock motor in reverse OFF/ON

      OFF: Charging connector lock motor or charging port lid lock motor not operated

      ON: Unlocking charging connector or charging port lid (operating charging connector lock motor or charging port lid lock motor in reverse)

      		 -
      Charging Connector Lock Motor Lock Direction Revolution Request Current Output of current to operate charging connector lock motor or charging port lid lock motor forward OFF/ON

      OFF: Charging connector lock motor or charging port lid lock motor not operated

      ON: Unlocking charging connector or charging port lid (operating charging connector lock motor or charging port lid lock motor forward)

      		 -

      • *1: for Electric Vehicle Charger Cable Assembly (Type A)

      • *2: for Electric Vehicle Charger Cable Assembly (Type B)