FUEL LID OPENER SYSTEM DATA LIST / ACTIVE TEST


  1. Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    DATA LIST


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List.

    5. Read the Data List according to the display on the GTS.


      Powertrain > Engine > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Fuel Filler Opener Fuel lid lock with motor assembly status* OFF or ON

      OFF: Fuel lid lock with motor assembly not operating

      ON: Fuel lid lock with motor assembly operating

      		 -
      Fuel Lid SW Fuel lid opener switch status Close or Open

      Close: Fuel lid opener switch not pushed

      Open: Fuel lid opener switch pushed

      		 -
      Fuel Lid Sensor SW Fuel lid courtesy switch status* Close or Open

      Close: Fuel lid closed

      Open: Fuel lid open

      		 -

      • *: w/ Canister Pump Module

  2. Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    ACTIVE TEST (w/ Canister Pump Module)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Powertrain > Engine > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Activate the Fuel Filler Opener Fuel lid lock with motor assembly OFF or ON -