LOW PRESSURE MAGNETIC VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during low pressure magnetic valve removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly	Ultrasonic sensor detection angle (w/ Intuitive Parking Assist System) Ultrasonic sensor detection angle registration (w/ Intuitive Parking Assist System)	Intelligent clearance sonar system Simple advanced parking guidance system	Click here
Front bumper assembly	Change grille shutter control mode and/or perform initialization	Grille Shutter system	Click here

Note

As a pipe may deform or its joint may be damaged if force is applied to the pipe, do not carry the accumulator and accessory assembly by a pipe or apply excessive force to a pipe while performing work.

PROCEDURE

REMOVE ACCUMULATOR AND ACCESSORY ASSEMBLY

Click here
REMOVE NO. 3 RECEIVER TANK BRACKET

Click here
REMOVE AIR CONDITIONING RECEIVER TANK WITH BRACKET

Click here
REMOVE NO. 6 COOLER BRACKET

Click here
REMOVE NO. 1 RECEIVER TANK BRACKET WITH NO. 5 COOLER BRACKET

Click here
REMOVE COOLER REFRIGERANT LIQUID PIPE A

Click here
REMOVE NO. 3 CONNECTOR TUBE

Click here
REMOVE LOW PRESSURE MAGNETIC VALVE
1. Remove the bolt and low pressure magnetic valve with No. 4 connector tube.
2. Remove the O-ring from the valve to connector tube.
  
  Note
  
  Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
3. Remove the bolt and low pressure magnetic valve.
4. Remove the O-ring from the No. 4 connector tube.
  
  Note
  
  Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.