AIR CONDITIONING ACCESSORY ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air conditioning accessory assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ Intuitive Parking Assist System)

  • Ultrasonic sensor detection angle registration (w/ Intuitive Parking Assist System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control mode and/or perform initialization Grille Shutter system

Click here

Note

As a pipe may deform or its joint may be damaged if force is applied to the pipe, do not carry the accumulator and accessory assembly by a pipe or apply excessive force to a pipe while performing work.

PROCEDURE


  1. REMOVE ACCUMULATOR AND ACCESSORY ASSEMBLY

    Click here

  2. REMOVE NO. 3 RECEIVER TANK BRACKET

    Click here

  3. REMOVE AIR CONDITIONING RECEIVER TANK WITH BRACKET


    1. A003KCU

      Disengage the 2 clamps.

    2. A003P0Q

      Remove the 4 bolts.

    3. A003LX1C02
      B006IFV Remove in this Direction

      Remove the air conditioning receiver tank with bracket as shown in the illustration.

    4. Remove the O-ring from the No. 1 connector tube.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  4. REMOVE NO. 6 COOLER BRACKET

    Click here

  5. REMOVE NO. 1 RECEIVER TANK BRACKET WITH NO. 5 COOLER BRACKET


    1. A003OQL

      Loosen the bolt.

    2. Disengage the clamp.

      A003L3G

    3. Remove the 6 bolts and No. 1 receiver tank bracket with No. 5 cooler bracket.

  6. REMOVE COOLER REFRIGERANT LIQUID PIPE A

    Click here

  7. REMOVE NO. 1 AIR CONDITIONING ACCESSORY ASSEMBLY


    1. A003L2L

      Remove the bolt and No. 1 air conditioning accessory assembly.

    2. Remove the O-ring from the No. 2 connector tube.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.