HEAT PUMP ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heat pump ECU removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  2. REMOVE HEAT PUMP ECU ASSEMBLY


    1. A003O3W

      Disconnect the connector.

    2. Remove the 2 nuts and heat pump ECU assembly.