FRONT EVAPORATOR TEMPERATURE SENSOR

INSTALL EVAPORATOR TEMPERATURE SENSOR

*a	Fixed Part
*b	Sensor Part

Install the evaporator temperature sensor as shown in the illustration.

Installation Position

Part	Length
A	50.0 mm (1.97 in.)
B	61.1 mm (2.41 in.)

Note

Be sure to insert the evaporator temperature sensor only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the No. 1 cooler evaporator sub-assembly, insert the evaporator temperature sensor one row next to the one that has been used previously (X in the illustration).
After inserting the evaporator temperature sensor, do not apply excessive force to the wire.
Directly insert the evaporator temperature sensor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".

INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

INSTALL COOLER PIPE GROMMET

INSTALL NO. 1 DISCHARGE TUBE

INSTALL GROMMET

INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

INSTALL HEATER CLAMP