ROOM TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during room temperature sensor removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  4. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE SHIFTING HOLE COVER

    Click here

  6. REMOVE NO. 2 LOWER INSTRUMENT PANEL FINISH PANEL

    Click here

  7. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR


    1. A003NA6C01
      B006IFV Remove in this Direction

      Disengage the 2 claws as shown in the illustration.

    2. A003OLX

      Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor.