INTERNAL CONDENSER TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during internal condenser temperature sensor removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. REMOVE AIR CONDITIONER UNIT ASSEMBLY

    Click here

  2. REMOVE GROMMET

    Click here

  3. REMOVE NO. 1 DISCHARGE TUBE

    Click here

  4. REMOVE COOLER PACKING


    1. for LHD:


      1. A003ND4

        Remove the cooler packing.

    2. for RHD:


      1. A003NT1

        Remove the cooler packing.

  5. REMOVE INTERNAL CONDENSER TEMPERATURE SENSOR


    1. for LHD:


      1. A003LJU

        Remove the piping clamp and internal condenser temperature sensor.

    2. for RHD:


      1. A003P2Y

        Remove the piping clamp and internal condenser temperature sensor.