HEAT EXCHANGER TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during heat exchanger temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

  • Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEAT EXCHANGER TEMPERATURE SENSOR


    1. A003K3C

      Disconnect the connector.

    2. A003KVN

      Remove the No. 1 cooler pipe packing.

    3. A003ML8

      Disengage the clamp.

    4. Remove the piping clamp and heat exchanger temperature sensor.