FRONT SEAT CUSHION HEATER(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during front seat cushion heater assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note


  • After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

  • After the power switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

  • When the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal, open and close the fuel lid before turning the power switch on (IG) (for w/ Canister Pump Module).

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

    Click here

  9. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH


    1. A003K9T

      Remove the 15 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.