FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat outer belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • B006IJ0

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    • If an SRS part is accidentally deployed, it may cause a serious injury.

    B006IKV

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE REAR DOOR SCUFF PLATE

    Click here

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  7. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B006J5Y

      Disengage the 3 claws to remove the lap belt outer anchor cover.

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. B006I6C

      Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.

  9. REMOVE LOWER CENTER PILLAR GARNISH

    Click here

  10. REMOVE CENTER PILLAR GARNISH ASSEMBLY

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. B006I62

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. B006IOKC01
      *a Protective Tape
      *b Locking Button
      *c Release

      Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B006IZU

      Remove the 2 bolts.

    4. Disengage the 2 guides to remove the front seat outer belt assembly.

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B006HT3

      Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.