FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Intelligent clearance sonar system*1
		Simple intelligent parking assist system*1
		Pre-crash safety system
		Parking assist monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

Use the same procedure for the RHD and LHD.
The following procedure is for the LHD.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Click here
REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Click here
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
1. Disconnect each connector.
2. Disengage each clamp.
3. for Manual Seat:
  1. Remove the nut and front seat inner belt assembly.
4. for Power Seat:
  1. Remove the nut and front seat inner belt assembly.
5. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
1. Disconnect each connector.
2. Disengage each clamp.
3. Remove the nut and front seat inner belt assembly.
4. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.