REAR AIRBAG SENSOR INSTALLATION

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      B006IKV

    3. Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.

      B006I7LC01
      *a Correct *b Incorrect

    4. Engage the claw and install the rear airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the rear airbag sensor claw is securely inserted into the body hole.

    5. Connect the connector to the rear airbag sensor.

      B006H8DC15
      *a White Housing Lock *b Connect

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips


      • Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).

      • When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or the part (A) as it may result in an insecure connection.

    6. Check that there is no looseness in the installed parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE GARNISH

    Click here

  3. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY

    Click here

  4. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

  5. INSTALL REAR UNDER SIDE COVER LH (for LH Side)

    Click here

  6. INSTALL REAR UNDER SIDE COVER RH (for RH Side)

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE

    Click here

  8. INSTALL REAR SEAT ASSEMBLY

    for LH Side: Click here

    for RH Side: Click here

  9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  11. INSPECT SRS WARNING LIGHT

    Click here