SRS SEAT CUSHION AIRBAG ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH

   
   

   1. 

      Pass the airbag wire harness through the hole.

   2. Install the front seat cushion airbag assembly RH with 3 new nuts.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note

      
      

      • The nuts must not be reused.

      • Make sure that the front seat adjuster assembly RH is not deformed. If it is deformed, replace it with a new one.

   3. Engage the claw and 2 clamps.

      Tech Tips

      Engage the claw first.

2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

3. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

4. INSTALL FRONT SEAT INNER CUSHION SHIELD RH

   Click here

5. INSTALL FRONT SEAT CUSHION SHIELD RH

   Click here

6. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

7. INSTALL RECLINING HINGE COVER RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

8. CONNECT SEPARATE TYPE FRONT SEATBACK COVER

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

9. INSTALL FRONT SEAT ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here