CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B006HTM

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    B006IKV

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.

    B006IZOC02
    B006IOI Deployment Side

    Note

    When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      B006IKV
    3. B006J35C01
      *a Airbag Connector
      *b Airbag Connector Lock
      *c Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock and disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Using needle nose pliers, remove the 6 pins from the 6 clips (A).

      Note

      Do not damage the pins.

      B006HOKC01
      *A w/o Occupant Classification System - -
      *1 Pin *2 Spacer
      *a Clip (A) *b Clip (B)
      *c Spacer Location - -

    5. Using 2 screwdrivers, disengage the 2 claws of each clip (A) and separate the 6 clips (A) from the vehicle body as shown in the illustration.

      Tech Tips

      Separate the 6 clips (A) and curtain shield airbag assembly from the vehicle body as a unit.

    6. Disengage the 3 clips (B).

    7. While holding the curtain shield airbag assembly, remove the 3 bolts and curtain shield airbag assembly.

    8. Remove the 6 clips (A) and 2 spacers from the curtain shield airbag assembly.