KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      
   3. 

      *a	Airbag Connector
      *b	Airbag Connector Lock

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the airbag connector lock to install the airbag connector.

   5. Engage the 4 claws and hook to temporarily install the lower No. 1 instrument panel airbag assembly.

   6. Install the lower No. 1 instrument panel airbag assembly with the 2 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

   Click here

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. INSTALL COWL SIDE TRIM BOARD LH

   Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

7. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

   Click here

8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

   Click here

9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

11. INSPECT SRS WARNING LIGHT

    Click here