ELECTRICAL KEY OSCILLATOR(for Rear Floor) REMOVAL

PROCEDURE

1. REMOVE TONNEAU COVER ASSEMBLY

   Click here

2. REMOVE REAR NO. 2 FLOOR BOARD

   Click here

3. REMOVE REAR NO. 1 FLOOR BOARD

   Click here

4. REMOVE REAR SEAT ASSEMBLY

   Click here

5. REMOVE REAR DOOR SCUFF PLATE LH

   Click here

6. REMOVE REAR DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure as for the LH side.

7. REMOVE REAR UNDER SIDE COVER LH

   Click here

8. REMOVE REAR UNDER SIDE COVER RH

   Tech Tips

   Use the same procedure as for the LH side.

9. REMOVE REAR UNDER COVER

   Click here

10. REMOVE REAR CONSOLE BOX COVER

    Click here

11. REMOVE REAR SEAT CONSOLE BOX ASSEMBLY

    Click here

12. REMOVE REAR FLOOR FRONT BATTERY COVER BOARD

    Click here

13. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

    
    

    1. 

       Remove in this Direction

       Disconnect the connector.

    2. Using a clip remover, disengage the clamp to remove the No. 3 indoor electrical key antenna assembly as shown in the illustration.

       Note

       Be careful when removing the No. 3 indoor electrical key antenna assembly. If the No. 3 indoor electrical key antenna assembly is dropped, replace it with a new one.