TELEVISION CAMERA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear television camera assembly

  • Parking assist monitor system initialization

  • Rear television camera assembly optical axis (Back camera position setting)

 Parking assist monitor system

Click here

PROCEDURE


  1. REMOVE DOOR PULL HANDLE

    Click here

  2. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  3. REMOVE REAR TELEVISION CAMERA ASSEMBLY


    1. A003K88

      Disconnect the connector.

    2. A003K0L

      Remove the 2 nuts.

    3. A003M9SC01
      B006IFV Remove in this Direction

      Remove the rear television camera assembly as shown in the illustration.