CLEARANCE WARNING BUZZER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning buzzer removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive High Beam System
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B006IJ0

PROCEDURE


  1. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 1 CLEARANCE WARNING BUZZER


    1. for LHD:


      1. A003MEO

        Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the No. 1 clearance warning buzzer.

    2. for RHD:


      1. A003N4Z

        Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the No. 1 clearance warning buzzer.

  3. REMOVE NO. 2 CLEARANCE WARNING BUZZER


    1. for LHD:


      1. A003KXS

        Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the No. 2 clearance warning buzzer.

    2. for RHD:


      1. A003LQV

        Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the No. 2 clearance warning buzzer.