SIMPLE INTELLIGENT PARKING ASSIST SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > IPA/ICS/Clearance Sonar > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      IPA Avoidance Distance Simple intelligent parking assist avoidance distance setting Short, Standard, Long or Max The selected customized value is displayed -
      IPA Perpendicular Parking Control Area Simple intelligent parking assist perpendicular parking range setting Small, Middle, Large or Max The selected customized value is displayed -
      IPA Parallel Parking Control Area Simple intelligent parking assist parallel parking range setting Small, Middle, Large or Max The selected customized value is displayed -
      IPA System Existence of simple intelligent parking assist system Without, With or Unfixed

      Without: w/o Simple intelligent Parking Assist System

      With: w/ Simple intelligent Parking Assist System

      Unfixed: Unknown

      		 -
      IPA Switch S-IPA switch signal OFF or ON

      ON: S-IPA switch on

      OFF: S-IPA switch off

      		 -
      Side Sensor Alarm Function Side sensor alarm function OFF or ON

      ON: Side sensor alarm function on

      OFF: Side sensor alarm function off

      		 -
      Bumper Type Registered bumper type Unfixed or 127

      1: Standard

      2 to 127: Unknown

      Unfixed: Unknown

      		 -
      Tire Circumference Compensation when tires are replaced Short 3, Short 2, Short 1, Standard, Long 1, Long 2 or Long 3

      Short 3: Small 3

      Short 2: Small 2

      Short 1: Small 1

      Standard: Standard

      Long 1: Large 1

      Long 2: Large 2

      Long 3: Large 3

      		 -
      # Codes Number of stored DTCs 0 to 255 Number of DTCs will be displayed -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test by referring to the table below.


      Body Electrical > Combination Meter > Active Test
      Tester Display Control Range Diagnostic Note
      Intelligent Parking Assist Indicator S-IPA indicator light on/off -