NAVIGATION RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation receiver assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Intelligent clearance sonar system*1
		Simple intelligent parking assist system*1
		Pre-crash safety system
		Adaptive high beam system
		Parking assist monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click here
REMOVE INSTRUMENT PANEL FINISH PANEL END RH

Click here
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here
REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
1. Remove the 4 bolts.
2. Remove in this Direction
  
  Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 guides.
3. Disconnect each connector and remove the navigation receiver assembly with bracket.
REMOVE NO. 1 RADIO BRACKET
1. Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET
1. Remove the 3 screws and No. 2 radio bracket.
REMOVE NAVIGATION RECEIVER ASSEMBLY