NAVIGATION SYSTEM(for Navigation Receiver Type) Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

A003P9IE35
*a MUTE
*b Stereo Component Amplifier Assembly
*c Navigation Receiver Assembly

PROCEDURE


  1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. A003M3UC60
      *a

      Component with harness connected

      (Stereo Component Amplifier Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I64-1 (MUTE) - Body ground

      Power switch on (ACC)

      Audio system playing

      → Audio system changing modes

      2.0 V or higher

      → Below 1 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the I33 navigation receiver assembly connector.

    2. Disconnect the I64 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I33-16 (MUT1) - I64-1 (MUTE) Always Below 1 Ω
      I33-16 (MUT1) or I64-1 (MUTE) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. Disconnect the I33 navigation receiver assembly connector.

    2. A003P3QC33
      *a

      Front view of wire harness connector

      (to Navigation Receiver Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I33-16 (MUT1) - Body ground

      Power switch on (ACC)

      Audio system playing

      		 2.0 V or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here