REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  2. REMOVE REAR ARMREST ASSEMBLY

    Click here

  3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP WITH REAR DOOR NO. 2 VENT SEAL

    Click here

  6. REMOVE REAR SPEAKER ASSEMBLY


    1. A003KTM

      Disconnect the connector.

    2. A003NDZ

      Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads.

      Note


      • Do not touch the speaker cone.

      • Do not drill the rivet at an angle as this will cause damage to the drill and rivet installation hole. Line up the drill with the rivet, and carefully drill out the rivet head.

      • Be careful as the drilled rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

    5. A003M35

      Disengage the 2 guides to remove the rear speaker assembly.