FRONT DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    1. Engage the 2 guides to temporarily install the front No. 1 speaker assembly.

    2. Using an air riveter or a hand riveter, install the front No. 1 speaker assembly with 3 new rivets.

      for LH Side:

      A003KF0C01
      *a Incorrect *b Correct
      *c Riveter *d Mandrel

      for RH Side:

      A003NTJC01
      *a Incorrect *b Correct
      *c Riveter *d Mandrel

      Note


      • Do not touch the speaker cone.

      • Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.

      • Confirm that the rivets are seated properly against the speaker.

      • Do not tilt the riveter when installing the speaker with the rivets.

      • Do not leave any space between the rivet heads and speaker.

      • Do not leave any space between the speaker and door. Firmly hold the speaker and door together while installing the rivets.

      Tech Tips


      • Install the rivets in the order shown in the illustration.

      • If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

    3. Connect the connector.

  2. INSTALL FRONT DOOR VENT SEAL

    Click here

  3. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  5. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  8. INSTALL FRONT ARMREST ASSEMBLY

    Click here

  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here