HEATED STEERING WHEEL CONTROLLER INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. A003NZ7

      Install the steering wheel heater control assembly to the lower steering wheel boss cover with the 2 screws.

    2. Connect the connector to the steering wheel heater control assembly.

    3. Engage the clamp.

    4. A003NBI

      Engage the 6 claws and 4 pins to install the lower steering wheel boss cover to the steering wheel assembly.

  2. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  3. INSTALL CRUISE CONTROL SWITCH WIRE

    Click here

  4. INSTALL CRUISE CONTROL MAIN SWITCH

    Click here

  5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  6. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  7. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  8. CHECK STEERING WHEEL CENTER POINT

  9. INSTALL HORN BUTTON ASSEMBLY

    Click here