PARKING BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL PARKING BRAKE PEDAL ASSEMBLY


    1. Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.

    2. B006I01

      Install a new clip to the No. 1 parking brake cable assembly.

    3. B006I3I

      Temporarily install a new No. 1 wire adjusting nut to the No. 1 parking brake cable assembly.

      Note

      If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.

    4. B006IAU

      Bend the parking brake pedal assembly claw.

  2. CONNECT PARKING BRAKE PEDAL ASSEMBLY


    1. B006IR4

      Install the parking brake pedal assembly to the vehicle body with the bolt and 2 nuts.

      Torque:
      Bolt
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }
      Nut
      15.5 N*m  { 158 kgf*cm, 11 ft.*lbf }
    2. B006HHC

      Connect the parking brake switch connector.

    3. Engage the clamp.

  3. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. B006H9T

      Install the No. 1 parking brake cable assembly with the bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  4. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY

    Click here

  7. INSPECT PARKING BRAKE PEDAL TRAVEL

    Click here

  8. ADJUST PARKING BRAKE PEDAL TRAVEL

    Click here

  9. INSPECT BRAKE WARNING LIGHT

    Click here

  10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  11. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  12. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  13. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  14. INSTALL COWL SIDE TRIM BOARD LH

    Click here

  15. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  16. INSTALL NO. 1 AIR DUCT

    Click here

  17. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  18. INSTALL FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  19. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  20. INSTALL REAR CONSOLE BOX ASSEMBLY (w/o Solar Charging System)

    Click here

  21. INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Solar Charging System)

    Click here

  22. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  23. PERFORM INITIALIZATION AND CALIBRATION

    Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization: Click here

  24. CHECK AND CLEAR DTC

    Click here