PARKING BRAKE SYSTEM ADJUSTMENT

PROCEDURE


  1. INSPECT PARKING BRAKE PEDAL TRAVEL


    1. Completely release the parking brake pedal.

    2. Fully depress the parking brake pedal to engage the parking brake.

    3. Depress the parking brake pedal again to disengage the parking brake.

    4. B006HKY

      Slowly depress the parking brake pedal using the specified force, and count the number of clicks.

      Parking Brake Pedal Travel
      8 to 11 notches at 300 N (31 kgf, 67.4 lbf)

      If the parking brake pedal travel is not as specified, adjust the parking brake pedal travel.

  2. ADJUST PARKING BRAKE PEDAL TRAVEL


    1. Completely release the parking brake pedal.

    2. B006IMU

      Turn the No. 1 wire adjusting nut until the parking brake pedal travel is corrected to within the specified range.

      Parking Brake Pedal Travel
      8 to 11 notches at 300 N (31 kgf, 67.4 lbf)

      Note

      If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.

    3. Operate the parking brake pedal 3 to 4 times, and check the parking brake pedal travel.

      Parking Brake Pedal Travel
      8 to 11 notches at 300 N (31 kgf, 67.4 lbf)

    4. Check that the parking brake does not drag.

    5. B006IKDC07
      *a Stopper
      *b Operation Lever

      Release the parking brake pedal and check that the clearance between the rear disc brake cylinder assembly operation lever and the stopper is as specified below.

      Clearance
      0.5 mm (0.0197 in.) or less

      If the clearance is not as specified, replace the rear disc brake cylinder assembly.

  3. INSPECT BRAKE WARNING LIGHT


    1. When operating the parking brake pedal, check that the brake warning light illuminates.

      Standard
      The brake warning light always illuminates at the first click.