STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Replacement of steering sensor Steering angle neutral point (Initialize intelligent clearance sonar system)

  • Intelligent clearance sonar system

  • Simple intelligent parking assist system

  • Parking assist monitor system

Click here

Steering angle setting Parking assist monitor system

Click here

CAUTION / NOTICE / HINT

Note

If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.

PROCEDURE


  1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  2. REMOVE STEERING SENSOR


    1. A003M3F

      Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.

      Note

      Do not damage the claws or pins of the spiral cable sub-assembly.