TIRE PRESSURE WARNING RECEIVER INSTALLATION
PROCEDURE
-
INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
Note
-
Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.
-
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
-
*A for Type A *B for Type B Connect the connector.
-
Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.
- Torque:
- for Type A
- 8.3 N*m { 85 kgf*cm, 73 in.*lbf }
- for Type B
- 10 N*m { 102 kgf*cm, 7 ft.*lbf }
Note
There are 4 types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.
-
-
INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
-
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
-
INSTALL ROPE HOOK (for LH Side without Toyota Safety Sense)
-
INSTALL NO. 2 ROPE HOOK (for LH Side without Toyota Safety Sense)
-
INSTALL NO. 1 TONNEAU COVER HOLDER CAP (for LH Side with Toyota Safety Sense)
-
INSTALL TONNEAU COVER HOOK A (for LH Side with Toyota Safety Sense)
-
INSTALL REAR SEAT SIDE GARNISH LH
-
INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
-
INSTALL REAR UNDER SIDE COVER LH
-
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
-
INSTALL REAR DOOR SCUFF PLATE LH
-
INSTALL REAR SEAT CUSHION LOCK HOOK
-
INSTALL REAR SEAT CUSHION ASSEMBLY LH
-
INSTALL REAR SEATBACK ASSEMBLY LH
-
INSTALL REAR SEAT HEADREST ASSEMBLY
-
INSTALL REAR DECK TRIM COVER
-
INSTALL DECK TRIM SERVICE HOLE COVER
-
INSTALL DECK FLOOR BOX RH
-
INSTALL DECK FLOOR BOX LH
-
INSTALL REAR NO. 1 FLOOR BOARD
-
INSTALL REAR NO. 3 FLOOR BOARD
-
INSTALL REAR NO. 4 FLOOR BOARD
-
INSTALL REAR NO. 2 FLOOR BOARD
-
INSTALL TONNEAU COVER ASSEMBLY
-
REGISTER TRANSMITTER ID
-
INSPECT TIRE PRESSURE WARNING SYSTEM
-
PERFORM INITIALIZATION