REAR UPPER ARM INSTALLATION

PROCEDURE


  1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A003P2RN01

      Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • Insert the bolt with the threaded end facing the front of the vehicle.

    2. Position the rear upper control arm assembly LH as shown in the illustration.

      Reference Length (A)
      1.2 mm (0.0472 in.)

    3. Fully tighten the bolt.

      Torque:
      73 N*m  { 744 kgf*cm, 54 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  2. INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here