REAR STABILIZER BAR INSTALLATION

PROCEDURE


  1. INSTALL REAR STABILIZER BUSHING


    1. Install the 2 rear stabilizer bushings to the rear stabilizer bar.

      Note

      Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

  2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET


    1. A003M89C02
      *a Arrow Mark
      B006IKP Front of the Vehicle

      Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.

      Note

      Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.

  3. INSTALL REAR STABILIZER BAR


    1. A003MWOC02
      *a Identification Mark

      Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts.

      Torque:
      78 N*m  { 795 kgf*cm, 58 ft.*lbf }

      Note


      • Ensure that the identification mark faces the right side of the vehicle.

      • Temporarily tighten the bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).

  4. STABILIZE SUSPENSION

    Click here

  5. INSTALL REAR STABILIZER LINK ASSEMBLY LH


    1. A003L68N01

      Install the rear stabilizer link assembly LH with the nut (A).

      Torque:
      75 N*m  { 765 kgf*cm, 55 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

    2. Install the rear stabilizer link assembly LH with the bolt and nut (B).

      Torque:
      75 N*m  { 765 kgf*cm, 55 ft.*lbf }

      Note

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

  6. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  7. INSTALL REAR FLOOR SIDE MEMBER COVER LH

    w/ Canister Pump Module: Click here

    w/o Canister Pump Module: Click here

  8. INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY

    w/ Canister Pump Module: Click here

    w/o Canister Pump Module: Click here

  9. INSTALL REAR WHEEL

    Click here