MILLIMETER WAVE RADAR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

PROCEDURE


  1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

    Note

    If any of the front bumper assembly, radiator grill, millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket has been replaced, check that the beam axis change mechanism is at the standard position (centered).


    1. A003NU8N01

      Set beam axis to the standard position.


      1. Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

        Specified Condition
        Difference between (A) and (B)
        1 mm (0.0394 in.) or less
        Torque:
        1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
    2. A003OJCC02
      B006IR6 Bolt
      B006IKP Screw

      Engage the 2 guides.

    3. Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.

      Torque:
      Bolt
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

    4. Connect the connector.

  2. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  3. ADJUST MILLIMETER WAVE RADAR SENSOR


    1. When the millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

      Click here