AUXILIARY BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

      Click here

    • When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. B006ID5

      Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

  3. REMOVE AUXILIARY BATTERY


    1. Disengage the 2 claws and open the battery terminal cap in the order shown in the illustration.

      B006ISTC02
      *a Top View of Claws - -
      B006J86 Push Battery Terminal Cap Here B006IFV Push
      B006IV0 Open - -
    2. B006I4A

      Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.

    3. B006I3H

      Remove the bolt.

    4. B006IQC

      Remove the No. 2 battery clamp as shown in the illustration.

    5. Remove the auxiliary battery.

    6. Remove the battery insulator from the auxiliary battery.