REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Note

When reusing the rear flexible hoses, use the identification marks created during removal to install each rear flexible hose to its original position.

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

INSTALL REAR FLEXIBLE HOSE

Note

When installing the rear flexible hose, minimize twisting of the hose.
1. *a Torque Wrench Fulcrum Length
  
  *b Union Nut Wrench
  
  Install the rear flexible hose with a new clip.
  
  Note
  
  Install the clip as far as it will go.
2. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
  
  Torque:
  
  Specified tightening torque
  
  15.2 N*m { 155 kgf*cm, 11 ft.*lbf }
  Note
  - Do not kink or damage the brake line.
  - Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
  Tech Tips
  - Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
    
    Click here
  - When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
    
    13.38 N*m (136 kgf*cm, 10 ft.*lbf)
3. Install the rear flexible hose with the bolt.
  
  Torque:
  
  29 N*m { 296 kgf*cm, 21 ft.*lbf }
4. Install the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.
  
  Torque:
  
  33.3 N*m { 340 kgf*cm, 25 ft.*lbf }
  
  Note
  
  Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
1. Connect the reservoir level switch connector.
2. Connect the cable to the negative (-) auxiliary battery terminal.
  
  Click here
3. Clear the DTCs.
  
  Click here
BLEED BRAKE LINE

Click here
INSTALL REAR WHEEL

Click here

*a	Torque Wrench Fulcrum Length
*b	Union Nut Wrench