REAR DISC BRAKE PAD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear disc brake pad removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Auxiliary battery terminal is disconnected/reconnected	Memorize steering angle neutral point	Lane departure alert system (w/ Steering control)	Click here
		Intelligent clearance sonar system*1
		Simple intelligent parking assist system*1
		Pre-crash safety system
		Adaptive high beam system
		Parking assist monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.
Click here Click here

Note

Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be stored. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
DISABLE BRAKE CONTROL

Click here
REMOVE REAR WHEEL

Click here
LOOSEN NO. 1 WIRE ADJUSTING NUT

for LHD: Click here

for RHD: Click here
REMOVE PARKING BRAKE LEVER PROTECTOR

Click here
SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

Click here
SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY

CAUTION:

Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.
1. *a Turn
  
  *b Hold
  
  Hold the rear disc brake pad guide pins and remove the bolt.
2. Pull the rear disc brake cylinder assembly upward.
REMOVE REAR DISC BRAKE PAD KIT
1. Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.
REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT

Click here

*a	Turn
*b	Hold