SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

    for SFI system (w/ Canister Pump Module)

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here


    for SFI system (w/o Canister Pump Module)

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE FRONT WIPER ARM HEAD CAP (for LHD, RHD Type A)

    Click here

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for LHD, RHD Type A)

    Click here

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for LHD, RHD Type A)

    Click here

  4. REMOVE COWL WATER EXTRACT SHIELD LH (for LHD, RHD Type A)

    Click here

  5. REMOVE COWL WATER EXTRACT SHIELD RH (for LHD, RHD Type A)

    Click here

  6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD, RHD Type A)

    Click here

  7. SEPARATE CENTER NO. 1 COWL TOP VENTILATOR LOUVER (for RHD Type B)

    Click here

  8. REMOVE IGNITION COIL ASSEMBLY

    Click here

  9. REMOVE SPARK PLUG


    1. B006ITZ

      Remove the 4 spark plugs from the cylinder head sub-assembly.

      Note

      If a spark plug has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.