| DTC Code | DTC Name |
|---|---|
| P157800 | Brake System |
DESCRIPTION
This DTC is output when the electronically controlled brake system has a problem. Check the electronically controlled brake system when this DTC P157800 is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P157800 | Brake System | When the power switch is on (IG) and the cruise control system is operating, a malfunction in the electronically controlled brake system is detected for 0.2 seconds or more. |
|
CAUTION / NOTICE / HINT
Note
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
PROCEDURE
CHECK FOR DTCS (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here |
| A |
|
CHECK FOR DTCS (CRUISE CONTROL SYSTEM)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control system operation is possible.
Turn the cruise control system on using the cruise control main switch (ON-OFF).
Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
Check for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
REPLACE HYBRID VEHICLE CONTROL ECU Click here |