RADIATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. REMOVE FAN ASSEMBLY

    Click here

  2. DISCONNECT NO. 1 RADIATOR HOSE


    1. A003P22

      Slide the clip and disconnect the No. 1 radiator hose.

  3. REMOVE RADIATOR ASSEMBLY


    1. A003K1M

      Disengage the 2 claws.

    2. Disengage the 2 guides to separate the cooler condenser assembly from the radiator assembly.

      Note

      Make sure not to damage the cooler condenser assembly when removing the radiator assembly.

    3. Remove the radiator assembly from the vehicle body.

      Note

      Do not apply excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.

    4. A003NRN

      Slide the clip and remove the No. 1 radiator hose.

  4. REMOVE RADIATOR SUPPORT GROMMET


    1. Remove the 2 radiator support grommets from the radiator assembly.