EXHAUST PIPE GAS CONTROL ACTUATOR REMOVAL

PROCEDURE

1. REMOVE REAR ENGINE UNDER COVER LH

   Click here

2. DRAIN ENGINE COOLANT (for Engine)

   Click here

3. REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR

   
   
   1. 

      *1	Outlet Heater Water Hose B
      *2	Outlet Heater Water Hose C
      *a	No. 2 Outlet Water Pipe
      *b	Inlet Water Pipe

      Slide the 2 clips and disconnect the outlet heater water hose B and outlet heater water hose C from the inlet water pipe and No. 2 outlet water pipe.

   2. 

      *a	Protective Tape
      *b	Spring

      Using a screwdriver with its tip wrapped with protective tape, pry the portion shown in the illustration to disengage the spring.

   3. 

      *a	No. 1 Outlet Water Pipe
      *b	No. 2 Outlet Water Pipe
      *c	Inlet Water Pipe

      Remove the 3 bolts and exhaust pipe gas control actuator sub-assembly and exhaust pipe gas control actuator gasket.

      Note

      
      

      • When removing the exhaust pipe gas control actuator sub-assembly, use caution because engine coolant may spill out from the exhaust heat recirculation system.

      • Do not apply any excessive force to the No. 1 outlet water pipe, No. 2 outlet water pipe and inlet water pipe when removing the exhaust pipe gas control actuator sub-assembly.

   4. 

      *1	Exhaust Pipe Gas Control Actuator
      *a	Inlet Water Pipe
      *b	No. 2 Outlet Water Pipe

      While closing No. 2 outlet water pipe, apply compressed air to inlet water pipe to remove the exhaust pipe gas control actuator shown in the illustration.

      Tech Tips

      Use a piece of cloth to catch the exhaust pipe gas control actuator.