SPEED LIMITER SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result
   Proceed to NEXT

   
   

   NEXT

2. INSPECT AUXILIARY BATTERY VOLTAGE

   
   

   1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

      Result
      Proceed to NEXT

   
   

   NEXT

3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

   
   

   1. Using the GTS, check if the CAN communication system is functioning normally.

      Result
      Result Proceed to CAN DTCs are not output A CAN DTCs are output B

   
   

   B

   GO TO CAN COMMUNICATION SYSTEM Click here

   A

4. CHECK FOR DTC*

   Refer to DTC Check / Clear.

   Click here

   
   

   1. Check for DTCs and note any codes that are output.

   2. Clear the DTCs.

      
      Powertrain > Hybrid Control > Clear DTCs

   3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      
      Powertrain > Hybrid Control > Trouble Codes

      Result
      Result Proceed to DTC does not reoccur A DTC reoccurs B

   
   

   B

   GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

   A

5. PROBLEM SYMPTOMS TABLE

   Refer to Problem Symptoms Table.

   Click here

   Result
   Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B

   
   

   B

   GO TO STEP 7 Click here

   A

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

   
   

   1. Operation Check

      Click here

   2. Terminals of ECU

      Click here

   3. Data List / Active Test

      Click here

      Result
      Proceed to NEXT

   
   

   NEXT

7. ADJUST, REPAIR OR REPLACE

   Result
   Proceed to NEXT

   
   

   NEXT

8. CONFIRMATION TEST

   Result
   Proceed to NEXT

   
   

   NEXT

   END