FUEL PUMP(w/ Canister Pump Module)

INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Install a new fuel suction tube set gasket to the fuel tank assembly.
Set the fuel suction tube with pump and gauge assembly to the fuel tank assembly.

Note

Be careful not to bend the arm of the fuel sender gauge assembly.
*a Protrusion

Notch

Align the protrusions of the fuel suction tube with pump and gauge assembly with the notches in the fuel tank assembly.

INSTALL FUEL PUMP GAUGE RETAINER

Install the fuel pump gauge retainer.

While pressing down on the fuel suction tube with pump and gauge assembly, temporarily install the fuel pump gauge retainer.

Temporarily install SST (plate) and SST (claw) to the fuel pump gauge retainer.

Tech Tips

Securely insert the ends of SST (claw) into the insertion points in the fuel pump gauge retainer.

While firmly pressing SST (claw) into the insertion points in the fuel pump gauge retainer, tighten SST (bolt).

*a	Triangle Mark (Fuel Pump Gauge Retainer)
*b	Triangle Mark (Fuel Tank Assembly)
*c	SST (Handle)
*d	SST (Plate)
*e	SST (Claw)
*f	SST (Bolt)
*g	Extension Bar (270 mm)
	Front Side

Install SST (handle) and an extension bar (270 mm) to SST (plate).

CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

Push the fuel tube joint onto the plug of the fuel suction plate sub-assembly, then install the tube joint clip.

*1	Fuel Suction Plate Sub-assembly	*2	Tube Joint Clip
*3	Fuel Tank Main Tube Sub-assembly	-	-
*a	Fuel Tube Joint	*b	O-ring
*c	Correct	*d	Incorrect
*e	Collar	-	-
	Insert		Insert

Note

Check that there are no scratches or foreign matter around the connecting parts of the fuel tube joint and plug before performing this work.
Check that the fuel tube joint is securely inserted to the end.
Check that the tube joint clip is on the collar of the fuel tube joint.
After installing the tube joint clip, check that the fuel tank main tube sub-assembly is securely connected by pulling on it.

INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

INSTALL REAR FLOOR SERVICE HOLE COVER

Remove any remaining butyl tape from the rear floor service hole cover and vehicle body.
Clean the installation surfaces of the rear floor service hole cover and vehicle body.
Connect the fuel pump connector and fuel tank pressure sensor (vapor pressure sensor) connector.

*a	Rear Floor Service Hole Cover (Back Side)
*b	Butyl Tape Adhesion Area

Install the rear floor service hole cover with new butyl tape.

Note

Securely install the rear floor service hole cover.

INSTALL CENTER REAR SEATBACK HINGE SUB-ASSEMBLY

Install the center rear seatback hinge sub-assembly to the vehicle body with the 2 bolts.

Torque:

36.8 N*m { 375 kgf*cm, 27 ft.*lbf }
Engage the clamp to connect the wire harness to the center rear seatback hinge sub-assembly.
Connect the rear seat inner belt assembly LH connector.

CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

INSPECT FOR FUEL LEAK

INSTALL REAR SEAT CONSOLE BOX ASSEMBLY

INSTALL REAR CONSOLE BOX COVER

INSTALL REAR UNDER COVER