FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A003KQM

      Disengage the 2 clamps to disconnect the wire harness.

      Note

      Do not damage the wire harness.

    2. A003MC4

      Remove the harness protector from the wire harness.

      Note

      Do not damage the wire harness.

    3. A003LW6

      Disconnect the fuel sender gauge assembly connector.

    4. A003OFY

      Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.