FUSE BOX REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery terminal block removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Adaptive high beam system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Replacement of hybrid battery terminal block Perform high voltage fuse accumulated load history reset DTCs are stored

Click here

*1: When performing learning using the GTS.
Click here Click here

CAUTION:


  • B006HTF

    Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

    Click here

  • B006HUP

    To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE UPPER HYBRID BATTERY COVER SUB-ASSEMBLY

    Click here

  3. REMOVE HYBRID BATTERY TERMINAL BLOCK

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.

    Note

    Insulate the disconnected high-voltage connector with insulating tape.


    1. B006HBC

      Disconnect the 2 hybrid battery terminal block connectors.

    2. B006HNK

      Remove the nut and hybrid battery terminal block from the HV battery.