| DTC Code | DTC Name |
|---|---|
| P1CA400 | Charger Pre-charging Malfunction |
DESCRIPTION
The charge control ECU built into the electric vehicle charger assembly monitors its internal operation. If it detects a precharge malfunction, it stores a DTC. If these DTCs are output, replace the electric vehicle charger assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P1CA400 | Charger Pre-charging Malfunction | After plug-in charging is performed, precharge has not been completed for a certain amount of time. (1 trip detection logic) |
Electric vehicle charger assembly | Comes on | Master Warning Light: Comes on |
CONFIRMATION DRIVING PATTERN
Tech Tips
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Enter the following menus: Powertrain / Hybrid Control / Data List.
Check that "Hybrid Battery SOC" shows 70% or less.
Turn the power switch off and wait for 2 minutes or more.
Connect the electric vehicle charger cable assembly, and plug-in charge the vehicle for 30 seconds or more.
Disconnect the electric vehicle charger cable assembly and wait for 10 seconds or more.
Turn the power switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.
Check the DTC judgment result.
Tech Tips
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
PROCEDURE
REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY
| Result | ||
|---|---|---|
|
| NEXT |
|
COMPLETED |